Iso 4287

The actual profile is the profile resulting from the intersection of the workpiece surface and a plane normal to that surface and in a direction that maximizes the surface roughness value, normally at right angles to the lay of the machining marks. The measured profile is the profile . Since these specification standards were first drafte much knowledge has been gained into unambiguous and stable definitions of surface texture parameters. This new knowledge has been used in the present . Therefore this version remains current.

Current status : Published. ISO shall not be held responsible for identifying any or all such patent rights. Only informative sections of standards are publicly available. To view the full content, you will . Rauheitsprofil (R-Profil).

Bestimmende Größe für die Grenze zwischen. Геометрические характеристики изделий (GPS). Wenn nicht anders angegeben, ergibt sich der Wert einer Profilkenngröße durch Mittelung der Einzelergebnisse von direkt hintereinander liegenden Einzelmessstrecken.

If the parameter Rz is measured according to DIN, it is generally ad- mitted that the extreme value specified by ISO is matched providing that Rz ISO does not exceed Rz DIN. ThE ROUGhNESS PARAMETERS . The scope of this framework of ISO standards is to provide methods for general evaluation of surface texture using stylus profilometers which typically record profiles with lengths of several millimeters. The mathematics of course also works for profiles recorded by other tools and for . An alternative measure of surface roughness is the Rz value.

Rz as the maximum height of profile. Diese soll etwa senkrecht zu den Bearbei- tungsriefen verlaufen. Arithmetical mean deviation. The average deviation of all points roughness profile from a mean line over the evaluation length. Oberflächenbeschaffenheit.

An older means of specifying a range for Ra is RHR. This is a symbol on a drawing specifying a minimum and. Sie bildet die gemittelte Rautiefe zusammen.

Zahlenwert von Ra (ohne Kurzzeichen) Bearbeitungszugabe Bearbeitungsverfahren Kurzzeichen und Zahlenwert,. Dieses bildet ein gleichseitiges Dreieck mit einer sog. Fahne, das auf einer der Spitzen steht.